Vantec UGT-ST644R - 4 Channel SATA 6Gb/s PCIe RAID Host Card driver and firmware
Related Vantec UGT-ST644R Manual Pages
Download the free PDF manual for Vantec UGT-ST644R and other Vantec manuals at ManualOwl.com
User Guide - Page 2
... 3 1.1 Product Introduction 3 1.2 Features 3 1.3 System Requirements 4 1.4 Package Contents 4
Chapter 2: Getting Started 5 2.1 Hardware Layout 5 2.2 Hardware Installation 7 2.3 Creating and Managing Virtual Disk 7 2.3.1 Creating Virtual Disks 7 2.3.2 Managing Virtual Disks 13 2.4 Driver Installation 22 2.5 To Verify Driver Installation 22 2.6 What is HyperDuo 23
UGT-ST644R
Page 2
User Guide - Page 3
... Product Introduction
This board is a single-chip, PCI Express to four SATA Gen III 6Gb/s channels host controller that brings server-class features to the desktop.
This board enables the use of the industry's newest and fastest hard drives at 6Gb/s while providing backward compatibility to legacy SATA 1.5Gb/s or 3Gb/s drives. It uses the same cable and connectors as previous SATA generations to...
User Guide - Page 4
...HyperDuo Supports Windows® XP/Vista/7/8 and Server 2008 R2
1.3 System Requirements
PCI Express x4, x8 or x16 slot Windows® XP/Vista/7/8 and Server 2008 R2.
1.4 Package Contents
1 x 4 Channel 6-Port SATA 6Gb/s PCIe RAID Host Card 1 x Driver CD 1 x User Manual 1 x Low Profile Bracket 2 x SATA Cables
UGT-ST644R
Page 4
User Guide - Page 7
...devices to the 4 Channel 6-Port SATA 6Gb/s PCIe RAID Host Card. 6. Replace the slot bracket's holding screw to secure the card. 7. Secure the computer cover and reconnect the power cord.
2.3 Creating and Managing Virtual Disk
2.3.1 Creating Virtual Disks
This section describes the steps for creating virtual disks using the BIOS Configuration Wizard.
Press + to enter Marvell BIOS Setup
UGT-ST644R...
User Guide - Page 22
...Channel 6-Port SATA 6Gb/s PCIe RAID Host Card into your CD-ROM drive.
2. At the Windows desktop, click Start, then click Run. 3. Type D:\UGT-ST644R\Windows\Setup.exe, click OK. (Change
D:\ to match your CD-ROM drive letter) 4. Follow the on-screen instructions to complete the installation. 5. Restart Windows to complete the installation.
2.5 To Verify Driver Installation
1. Right click My Computer...
Flyer - Page 1
...: Interface:
UGT-ST644R 4 x Internal SATA 6Gb/s Ports (Backward Compatible with SATA II/I) 2 x External SATA (eSATA) Ports 111 x 68 x 18mm PCIe v2.0
System Requirement
PCI Express x4, x8 or x16 slot Windows® XP/Vista/7/8 and Server 2008 R2
Package Contents
1 x 4 Channel 6-Port SATA 6Gb/s PCIe RAID Host Card 1 x Driver CD 1 x User Manual 1 x Low Profile Bracket 2 x SATA Cables
Send us...