Lantronix xPico Wi-Fi Pi Plate driver and firmware
Drivers and firmware downloads for this Lantronix item
Related Lantronix xPico Wi-Fi Pi Plate Manual Pages
Download the free PDF manual for Lantronix xPico Wi-Fi Pi Plate and other Lantronix manuals at ManualOwl.com
User Guide - Page 2
... the Wi-Fi Alliance Corporation. Raspberry Pi is a registered trademark of the Raspberry Pi Foundation. All other trademarks, servicemarks and trade names are the property of their respective owners.
Warranty
For details on the Lantronix warranty policy, please go to our Web site at www.lantronix.com/support/warranty.
Contacts
Lantronix, Inc.
167 Technology Drive Irvine, CA 92618, USA Phone...
User Guide - Page 5
...lantronix.com/support/documentation for the latest documentation and the following additional documentation.
Document
Description
xPico Wi-Fi Pi Plate Quick Start Guide
Instructions for getting the xPico Wi-Fi module up and running on the Raspberry Pi computer board.
xPico Wi-Fi Embedded Device Server Product Brief
Provides a quick reference to xPico Wi-Fi technical specifications.
xPico Wi...
User Guide - Page 7
...software release.
Mini USB Type B connects to the xPico module serial port 2 through a USB to serial converter and the JP17 jumper headers.
Connects to 0.301 ohm current sense resistor R1. Uninstalled Measure voltage on JP1 to calculate module power consumption
Install to use WLAN LED
Installed
Install to use wake-up input and button,SW1
Installed
xPico® Wi-Fi® Pi Plate User Guide...
User Guide - Page 8
... JP3,JP5: 1-2 PI_TX1 (J1 pin 8) PI_RX1 (J1 pin 10)
Serial Port 2
Serial port 2 of the xPico Wi-Fi device has the signals TXD2 and RXD2. These signals go through jumpers JP17 pins 5 to 6 and 7 to 8. If the jumpers are installed the serial port is routed to an onboard USB to serial converter, which then connects to USB connector J9 on the board.
xPico® Wi-Fi® Pi Plate User Guide
8
User Guide - Page 9
... connections only while the module is powered off.
Power Supply
The Lantronix xPico Wi-Fi Pi Plate device is powered from the Raspberry Pi computer board when a jumper is installed to JP6 position 1 to 2. There is an option to power the board from the USB connectors when the board is run stand alone. If the board is run stand alone with no mating computer board, install the jumper on JP6 to...
User Guide - Page 10
... connects to xPico Wi-Fi module serial port 2 via a USB to serial converter. The xPico Wi-Fi has a USB device-side port that is connected to J8. The USB device port will be enabled with a future firmware update.
SPI and CP
The SPI and CP pins can be connected to the Raspberry Pi computer board with the jumpers onJP2. Please refer to the xPico Wi-Fi Embedded Device Server User Guide for details...
Quick Start Guide - Page 1
..., set the jumpers JP3 and JP5 to connect to the xPico Wi-Fi module serial port to the Raspberry Pi CPU serial port.
4. For Serial Port 2 operation, install jumpers on pins 5 to 6 and 7 to 8 of JP17. This will route the serial port 2 signals to the J9 USB port through the FTDI serial to USB converter device.
5. Connect power to the Raspberry Pi board. The Lantronix xPico Wi-Fi Pi plate module...