Lantronix C6310-3340 driver and firmware
Drivers and firmware downloads for this Lantronix item
Related Lantronix C6310-3340 Manual Pages
Download the free PDF manual for Lantronix C6310-3340 and other Lantronix manuals at ManualOwl.com
C6310-3340 and S6310-3340 User Guide Rev A - Page 1
x6310 ION POTS Media Converters
POTS 2-Wire Copper-to-Fiber
Install Guide
Part Number 33818 Revision A March 2022
C6310-3340 and S6310-3340 User Guide Rev A - Page 2
...Lantronix warranty policy, please go to http://www.lantronix.com/support/warranty.
Contacts
Lantronix Corporate Headquarters 7535 Irvine Center Drive Suite100 Irvine, CA 92618, USA Toll Free: 800-526-8766 Phone: 949-453-3990 Fax: 949-453-3995
Technical Support Phone...Rev. Comments
3/7/22 A
Initial Lantronix release at FW Version 2.0.0 Bootloader v 0.1.10, Hardware 1.0.0, FPGA rev 1.0.1. IONMM FW ...
C6310-3340 and S6310-3340 User Guide Rev A - Page 3
... ...14 Telephone In-use (Off-hook) ...14 Central Office (CO) Rings the Telephone ...14 Copper Cable-Category 1 ...14 Software Installation and Operation ...15 Remote Management ...15 Firmware Upgrade (C6310 SIC Only) ...15 CLI Commands ...16 General ...16 Command Line Editing ...16 Display Similar Commands...16 Partial Keyword Lookup...16 Recall Commands ...17 Commands Effect on Stored Files ...17...
C6310-3340 and S6310-3340 User Guide Rev A - Page 5
... configured to have the ability to act as a Central Office and connects to a telephone device (FXS Mode).
Ordering Information
Model #
Description
C6310-3340
Chassis card media converter; twisted Pair (RJ-11) (5 km/3.1 mi.) to open SFP Slot. Fiber Type, Optical Wavelength, Transmission Distance, and Link Budget all based on selected SFP module. Must be used...
C6310-3340 and S6310-3340 User Guide Rev A - Page 6
...strand fiber installations • SNMP Management supported when installed in a managed ION chassis • Supports remote management of paired unit, in-band, over the fiber • Electrical interface is provided through an RJ-11 female connector • Field upgradeable firmware • Only supports analog POTS lines • Compatible with traditional telephone modems
x6310 Specifications...
C6310-3340 and S6310-3340 User Guide Rev A - Page 9
Lantronix
x6310 ION POTS Media Converter User Guide
2 Installation
CAUTION: Wear a grounding device and observe electrostatic discharge precautions when setting the jumpers. Failure to observe this caution could result in damage to or failure of the module.
PC Board Layout
The PCB is shown below.
33818 Rev. A
https://www.lantronix.com/
Page 9 of 39
C6310-3340 and S6310-3340 User Guide Rev A - Page 11
...POTS Media Converter User Guide
Installing the Chassis Model (C6310)
The C6310 is a slide-in module that can only be installed in a Lantronix ION chassis (ION001-x, ION106-x, and ION219-x). This section describes how to install the C6310 in the ION chassis.
Caution: Failure to wear a grounding device and observe electrostatic discharge precautions when installing the C6310 could result in damage...
C6310-3340 and S6310-3340 User Guide Rev A - Page 12
... POTS Media Converter User Guide
Installing SFPs
The ION x6310 lets you install a Gigabit Ethernet Small Form-Factor Pluggable (SFP) device of your choice in order to make a fiber connection. See the Lantronix SFP page for models, safety precautions, and warnings specific to your SFP model. See the related SFP manual for more information.
Note: Do not...
C6310-3340 and S6310-3340 User Guide Rev A - Page 13
Lantronix
x6310 ION POTS Media Converter User Guide
Standard Configuration
In a standard configuration, the FXO Mode converter connects to the Central Office (CO) or PBX while the FXS Mode converter connects to the analog phone.
Install Fiber Cable
1. Locate a fiber cable with male, two-stranded TX to RX connectors installed at both ends. 2. Connect the fiber cables to FXS...
C6310-3340 and S6310-3340 User Guide Rev A - Page 15
... IONMM User Guide for information on how to Install the USB Driver, Configure HyperTerminal, Starting a USB Session in HyperTerminal, Terminating a USB Connection from HyperTerminal, Access via an Ethernet Network, Starting a Telnet Session, Terminating a Telnet Session, and Initial Setup with a Static IP Address via the CLI.
Firmware Upgrade (C6310 SIC Only)
The C6310 firmware can be upgraded in...
C6310-3340 and S6310-3340 User Guide Rev A - Page 16
... CLI is used during the initial setup (set ip, etc.) and troubleshooting, but can also be used for day-to-day management (device management, firmware upgrades, managing security features, etc.).
Note: CLI commands are case sensitive. Enter the CLI commands as shown. To execute the commands described in this manual, you must press the Enter key...
C6310-3340 and S6310-3340 User Guide Rev A - Page 17
... s=11 l1d
ION219-TestLab C1|S11|L1D>show card info
System name:
Uptime:
22:38:12
MAC:
00-c0-f2-8f-81-40
Number of ports: 2
Serial number:
4545
Config mode:
software
Software:
2.0.0
Bootloader:
0.1.10
Hardware:
1.0.0
FPGA rev:
1.0.1
ION219-TestLab C1|S11|L1D>
Command: show pots status
Description: Display device's current POTS status.
Syntax:
show pots status
Parameters...
C6310-3340 and S6310-3340 User Guide Rev A - Page 20
... sign in screen displays.
C6310 MAIN Tab
The chassis device (C6310) MAIN tab parameters are shown and described below. Note that read-only parameters are greyed out.
Parameter descriptions:
Model Information Serial Number: The device serial number (e.g., 4545). Model: The device model # (e.g., C6310-3340). Software Revision: The current version of device software (e.g., 2.0.0). Hardware Revision...
C6310-3340 and S6310-3340 User Guide Rev A - Page 21
Lantronix
x6310 ION POTS Media Converter User Guide
Configuration Mode: The current operating mode of the device (i.e., Software or Hardware). The default is Software mode. Number of Ports: The number of ports supported by this device (e.g., 2). MAC Address: The device's MAC address in the format 11-22-33-44-55-66.
Buttons (Model Information section): Uptime Reset: Click to reset (zero out) the ...
C6310-3340 and S6310-3340 User Guide Rev A - Page 22
Lantronix
x6310 ION POTS Media Converter User Guide
C6310 POTS Port 1 MAIN Tab
The chassis device (C6310) POTS Port 1 MAIN tab parameters are shown and described below. Note that readonly parameters are greyed out.
Parameter descriptions: Circuit ID : Entry field for the port circuit ID.
Port Configuration Hook Status : The current Hook status (OnHook or OffHook). Connector Type : The current...
C6310-3340 and S6310-3340 User Guide Rev A - Page 23
Lantronix
x6310 ION POTS Media Converter User Guide
C6310 Fiber Port 2 MAIN Tab
The chassis device (C6310) Fiber Port 2 MAIN tab parameters are shown and described below. Note that readonly parameters are greyed out.
Parameter descriptions: Circuit ID : Entry field for the port circuit ID.
Port Configuration Link Status : The current Link status (Up or Down). Connector Type : The current...
C6310-3340 and S6310-3340 User Guide Rev A - Page 24
Lantronix
x6310 ION POTS Media Converter User Guide
Remote S6310 Fiber Port 2 MAIN Tab
The standalone device (S6310) MAIN tab parameters are shown and described below. Note that read-only parameters are greyed out.
Parameter descriptions:
Model Information Serial Number: The device serial number (e.g., 8787). Model: The device model # (S6310-3340). Software Revision: The current version of ...
C6310-3340 and S6310-3340 User Guide Rev A - Page 25
... to reboot the device. Reset to Factory Config: Click to change the device's configuration back to its factory default settings. Refresh: Click to update the page data. Save: Click to save any parameter changes to the running-config file. Help: Click to display the related online Help page.
33818 Rev. A
https://www.lantronix.com/
Page 25...
C6310-3340 and S6310-3340 User Guide Rev A - Page 32
... as described in previous sections of this manual.
10. Check the device firmware version. Keep your products current by downloading the latest firmware. You must log in or create an account to download firmware.
11. If you still cannot resolve the problem, record model and system information and contact Technical Support.
33818 Rev. A
https://www.lantronix.com/
Page 32 of 39
C6310-3340 Product Brief - Page 2
... supported when installed in a managed ION chassis
● Supports remote management of paired unit, in-band, over the fiber
● Electrical interface is provided through an RJ-11 female connector
● Field upgradeable firmware
● Only supports analog POTS lines
● Compatible with traditional telephone modems
Ordering Information
Part Number C6310-3340
Description
Chassis Card...