Lantronix NM2-FXS-2230-SFP-01 driver and firmware

Drivers and firmware downloads for this Lantronix item

We have a direct link to download Lantronix NM2-FXS-2230-SFP-01 drivers, firmware and other resources directly from the Lantronix site. To protect our site from spammers you will need to verify you are not a robot below in order to access the download link.

Related Lantronix NM2-FXS-2230-SFP-01 Manual Pages

Download the free PDF manual for Lantronix NM2-FXS-2230-SFP-01 and other Lantronix manuals at ManualOwl.com

Fiber-to-the-Desk Application Note - Page 3

...NIC • PCI, PCIe or Express Card bus fiber NICs are securely installed within PC and provide a fiber connection between main computer room and desktop location • PCIe Fiber NICs with PoE enable VoIP Phones USB to Fiber Ethernet Adapter • Provides fiber connectivity point for laptops, tablets or thin clients; requires no external power supply M.2 Fiber Network Interface Card •...
M.2 Ethernet Fiber Network Interface Card Overview - Page 1

... Ethernet Fiber Network Interface Cards Applications • The M.2 Ethernet Fiber NIC is used to provide fiber-to-the-desktop for the designated Dell micro PCs and thin clients Features Internally mounted in small computing devices IEEE 802.3-2012 Fast Ethernet and Gigabit Ethernet versions available Use of A+E keyed M.2 interface Supports PXE boot Supports UEFI Supports jumbo frames Supports...
M.2 Ethernet Fiber Network Interface Card Overview - Page 2

..." [13 mm] Fiber Interface Dimensions: NM2-FXS-01 = 2.99" [76 mm], NM2-FXS-201 & NM2-GXE-201 = 5.013" [127.33 mm], FFC Cable NM2-GXE-201A = 4.911" [124.74 mm] Software Support Windows 10, 8, 8.1, and 7 (32/64 bit); Linux Power Source M.2 interface connector: 3.3V (Refer to table 41 of M.2 Specification) Environment Operating: 0°C to +45°C Storage: -40°C to 85°C Humidity...
NM2-FXS-01 Product Brief - Page 1

... port, and a 20-pin Flat Flex Cable (FFC) that connects the NIC to the fiber adapter. The fiber optic adapter is an open SFP with a 100Base-FX to SGMII SFP Module (included). Ordering Information NM2-FXS-2230-SFP-01 M.2 NIC, 100Base-FX to SGMII SFP media converter (included) Features ● PCI Express M.2 compliant ● A + E keyed M.2 interface ● Full duplex ● Flow control...
Installation Guide Rev D - Page 2

Lantronix NM2-FXS-2230-SFP-01 Install Guide Intellectual Property © 2022 Lantronix, Inc. All rights reserved. No part of the contents of this publication may be transmitted or reproduced in any form or by any means without the written permission of Lantronix. Lantronix is a registered trademark of Lantronix, Inc. in the United States and other countries. All other trademarks and trade names...
Installation Guide Rev D - Page 3

Lantronix NM2-FXS-2230-SFP-01 Install Guide Table of Contents Product Description...4 Ordering Information ...4 Features ...4 Package Contents...4 M.2 Specifications ...5 SFP Specifications ...6 System Board Layout...6 NIC Hardware Installation Overview ...7 NIC Hardware Location...7 Components Overview...8 Reference Views ...8 Pre-Installation Checklist ...10 Hardware Installation Procedure ......
Installation Guide Rev D - Page 4

... SFP Lantronix M.2 100-Base-FX Ethernet Fiber Network Interface Card (NIC) provides a fiber optic interface for the Dell OptiPlex™ 7040 and 7050 Micro PCs and the Wyse 7040/7050 Series thin clients. The NM2-FXS-2230-SFP-01 consist of a M.2 NIC that installs into the OptiPlex Micro PC's M.2 "A or E keyed" interface, a fiber optic adapter that installs into the OptiPlex Micro PC's Option port...
Installation Guide Rev D - Page 5

Lantronix NM2-FXS-2230-SFP-01 Install Guide Note that this NM2-FXS-2230-SFP-01 SFP transceiver is sold separately and also as a part of Lantronix' NM2-FXS-2230SFP-01 M.2 100-Base-FX Ethernet Fiber NIC. See the applicable SFP manual for more information on the SFP bundled with the M.2 NIC. M.2 Specifications M.2 module naming per specification: 2230-D4-A-E. Key IDs: A and E. Jumbo frame support...
Installation Guide Rev D - Page 6

... in below diagram) and one 22x80 slot (#13 in below diagram). The NM2-FXS-2230-SFP-01 installs in the 22x30 slot (#10 in below diagram). See the Dell OptiPlex 7040M Owner's Manual for more details. 1. Processor 2. CPU fan connector 3. Internal speaker connector 33730 Rev. D 11. Power switch 12. Hard drive connector 13. M.2 socket3 connector https://www.lantronix.com/ Page 6 of 17
Installation Guide Rev D - Page 7

Lantronix NM2-FXS-2230-SFP-01 Install Guide 4. Memory module connectors 5. USB 3.0 connector 6. Intrusion switch 7. USB 3.0 connector 8. Line out connector 9. Universal audio jack 10. M.2 socket1 connector 14. Coin cell battery 15. RJ-45 Ethernet connector 16. USB 3.0 connector 17. DP/VGA daughter board connector 18. DisplayPort connector 19. HDMI connector 20. DC-in jack NIC Hardware ...
Installation Guide Rev D - Page 8

Lantronix Components Overview NM2-FXS-2230-SFP-01 Install Guide Reference Views 33730 Rev. D https://www.lantronix.com/ Page 8 of 17
Installation Guide Rev D - Page 9

Lantronix NM2-FXS-2230-SFP-01 Install Guide CAUTION: Only qualified persons should install the NIC. Failure to observe this caution could result in poor performance or damage to the equipment. Before installing the NIC, review the Pre-Installation Checklist and Safety Precautions below. CAUTION: Wear a grounding device and observe electrostatic discharge precautions when installing the NIC in a ...
Installation Guide Rev D - Page 10

Lantronix NM2-FXS-2230-SFP-01 Install Guide Pre-Installation Checklist Before installing your NIC, review the preceding sections, and then do the following: 1. Verify that your system is using the latest BIOS. 2. If you download the driver software, record the path where you saved the downloads. 3. If your system is active, shut it down. Do not install the NIC until system power is completely ...
Installation Guide Rev D - Page 11

Lantronix NM2-FXS-2230-SFP-01 Install Guide Hardware Installation Procedure 1. Remove PC cover. 2. Gently remove the HDD Assembly. See the Dell or Wyse documentation. 3. Remove the 15-Pin DSUB knockout. 4. Install the M.2 NIC Assembly into Motherboard M.2 Edge Connector. 5. Secure the M.2 NIC Assembly into place using the Securing Screw 6. Install the Fiber Optic Adapter into the VGA opening in ...
Installation Guide Rev D - Page 12

Lantronix NM2-FXS-2230-SFP-01 Install Guide 12. Insert end of 20-Position FFC Cable into fiber optic adapter, with Pins facing down. 13. Push Locking Lever Down to Lock. Check that Cable is secure. See figure below for final placement. 14. Gently replace the HDD Assembly. 15. Replace PC cover. 16. Install the TN-SFP-GE-100FX in the open SFP slot, and then...
Installation Guide Rev D - Page 13

...for Windows Device Manager. When you install the Intel PROSet software, tabs are automatically added to the supported Intel adapters in Windows Device Manager. These features allow you to test and configure wired Intel® Ethernet Adapters. The links below apply to the NM2-FXS-2230-SFP-01. At each link, there is a 32-bit and a 64-bit download for each OS. Intel® Network Adapter Driver for...
Installation Guide Rev D - Page 14

Lantronix NM2-FXS-2230-SFP-01 Install Guide For More Information To view the Dell™ OptiPlex™ User's Guide at the Support Center web page: 1. Click Start → Help and Support → Dell User and System Guides → System Guides. 2. Click the User's Guide for your computer. The User's Guide is also available on the optional Drivers and Utilities media. Support for Wyse 7040/...
Installation Guide Rev D - Page 15

Lantronix NM2-FXS-2230-SFP-01 Install Guide Record Device and System Information After performing the troubleshooting steps, and before calling or emailing Technical Support, please record as much information as possible to help the Tech Support Specialist. Record the following information: 1. Product ID MAC Address Serial Board Rev LED status 2. Record the System information: Check your ...
Installation Guide Rev D - Page 16

Lantronix Declaration of Conformity NM2-FXS-2230-SFP-01 Install Guide 33730 Rev. D https://www.lantronix.com/ Page 16 of 17
Installation Guide Rev D - Page 17

Lantronix NM2-FXS-2230-SFP-01 Install Guide Lantronix Corporate Headquarters 7535 Irvine Center Drive Suite100 Irvine, CA 92618, USA Toll Free: 800-526-8766 Phone: 949-453-3990 Fax: 949-453-3995 Technical Support +1.952.358.3601, 1.800.260.1312, or [email protected] Sales Offices For a current list of our domestic and international sales offices, go to the Lantronix web site at www...
Get Help Online

Get immediate support for your Lantronix NM2-FXS-2230-SFP-01 questions from HelpOwl.com.

Recent Lantronix NM2-FXS-2230-SFP-01-related questions:

Lantronix Manuals

Find free Lantronix NM2-FXS-2230-SFP-01 manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Corporate Office

Locate the Lantronix corporate office headquarters phone number, address and more at CorporateOfficeOwl.com.

Contact Information

Complete Lantronix customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Lantronix customer service rankings, employee comments and much more from our sister site.