Lantronix EDS3000PS driver and firmware
Drivers and firmware downloads for this Lantronix item
Related Lantronix EDS3000PS Manual Pages
Download the free PDF manual for Lantronix EDS3000PS and other Lantronix manuals at ManualOwl.com
EDS3000 PS Product Brief A4 - Page 1
...with Windows-based Lantronix Provisioning Manager, which can be used locally or remotely with the Lantronix ConsoleFlow™ device management platform. A "Cisco-like" command-line interface (CLI) simplifies configuration and control, making it easier to integrate edge devices or data center equipment into the network. EDS3000PS leverages the Lantronix Com Port Redirector virtualization software...
EDS3000 PS Product Brief A4 - Page 2
EDS3000PS
Device Server: Serial to Ethernet
Features and Specifications
Hardware
• CPU: Cortex A9 • 4 Gbit (512 MB) Flash • 4 Gbit (512 MB) RAM • On-board memory: 8MB Flash • Ethernet 10/100/1000Mbps
Serial Interface
• Software selectable data rates from
• Modem Control Signals: CTS, RTS,
300 to 230K Baud
DTR, DCD
• Characters: 7 or 8 ...
EDS3000 PS Product Brief - Page 1
...with Windows-based Lantronix Provisioning Manager, which can be used locally or remotely with the Lantronix ConsoleFlow™ device management platform. A "Cisco-like" command-line interface (CLI) simplifies configuration and control, making it easier to integrate edge devices or data center equipment into the network. EDS3000PS leverages the Lantronix Com Port Redirector virtualization software...
EDS3000 PS Product Brief - Page 2
EDS3000PS
Device Server: Serial to Ethernet
Features and Specifications
Hardware
• CPU: Cortex A9 • 4 Gbit (512 MB) Flash • 4 Gbit (512 MB) RAM • On-board memory: 8MB Flash • Ethernet 10/100/1000Mbps
Serial Interface
• Software selectable data rates from
• Modem Control Signals: CTS, RTS,
300 to 230K Baud
DTR, DCD
• Characters: 7 or 8 ...
Command Reference - Page 3
... kernel version 3.6.5. https://www.kernel.org/pub/linux/kernel/COPYING
OPEN SOURCE SOFTWARE IS DISTRIBUTED WITHOUT ANY WARRANTY, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. SEE THE APPLICABLE LICENSE AGREEMENT FOR ADDITIONAL INFORMATION.
Revision History
Date August 2020 February 2021
Rev. A B
Comments Initial document. Updated document to firmware...
Command Reference - Page 69
... level for the network.
threshold
Sets the threshold in bytes. After this many bytes are received, they are forwarded without delay.
tunnel
Enters the tunnel level. = number of the tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent memory.
xoff char
Sets the xoff character for use with software flow control on this...
Quick Start Guide - Page 1
...100Mbps Link 1000Mbps Activity 1000Mbps
2. INSTALLATION
1. Power off the serial device that will be connected to the EDS3000PS. 2. Attach a RJ 45 serial cable between the EDS3000PS and your serial
device. 3. Connect an CAT5E Ethernet cable between the EDS3000PS Ethernet
port and your Ethernet network. 4. Connect the power cord and apply power. 5. Power up the serial device.
RS-232 Pin Assignment...
Quick Start Guide - Page 2
...(if the EDS3000PS already has an IP address). 2. Log in to the EDS3000PS. 3. Change network settings, if needed, in enable > config > if 1, or perform other configuration.
Lantronix ConsoleFlow™ - Software platform to centrally access and remotely manage your Lantronix device assets. Visit https://www.lantronix.com/consoleflow to request a free trial.
Contact Technical Support For technical...
User Guide - Page 2
...Lantronix warranty policy, please go to our website at www.lantronix.com/support/warranty.
Contacts
Lantronix, Inc. Corporate Headquarters
7535 Irvine Center Drive Suite 100 Irvine, CA 92618, USA Phone: 949-453-3990 Fax: 949-453-3995
Technical Support
Online: www.lantronix.com/support...://www.python.org/download/releases/2.7/license/
Linux kernel version 3.6.5.
EDS3000 Device Server User Guide
2
User Guide - Page 3
...device that are not explicitly approved by Lantronix will void the user's authority to operate this device.
Revision History
Date August 2020 February 2021
Rev. A B
Comments
Initial document.
Updated to firmware version 2.0.0.0R7. Updated installation and compliance information. Added TLS1.3 support. Renamed "MACH10" to "ConsoleFlow".
EDS3000 Device Server User Guide...
User Guide - Page 12
...
Chapter 3: Installation of EDS3000PR/ EDS3000PS Chapter 4: Using Lantronix Provisioning Manager Chapter 5: Configuration Using Web Manager Chapter 6: Network Settings Chapter 7: Filesystem Chapter 8: Diagnostics
Chapter 9: Administration
Appendix A: Technical Support Appendix B: Binary to Hexadecimal Conversions Appendix C: Compliance Appendix D: Lantronix Cables and Adapters
Description Main...
User Guide - Page 19
... the computer and serial-based devices traditionally controlled via a COM port. With SCPR installed at each computer, computers that were formerly "hard-wired" by serial cabling for security purposes or to accommodate applications that only understood serial data could instead communicate over an Ethernet network or the Internet.
Terminal Server/Device Management
Remote offices can have routers...
User Guide - Page 29
... to
proceed through an initial setup. 3. Locate the EDS3000 device in the device list. The device's firmware version, serial number, IP
address, and MAC address will be shown. Additional information can be obtained by clicking the three dot menu and clicking Get Device Info. 4. To perform operations on the EDS3000 device, such as upgrading the firmware, updating the configuration, or uploading to...
User Guide - Page 52
... Automatically reboot device after firmware or configuration update.
Note: Setting causes automatic reboot after a firmware update.
Active Connection
Select the connection instance to use when connecting to ConsoleFlow. The configuration options for both Connection 1 and Connection 2 are below.
Host
Enter the host name or IP address.
Connection 1
Connection 1 settings.
Port
Enter the...
User Guide - Page 55
...:
FTP
The FTP protocol can be used to upload and download user files as well as upgrade the EDS3000 devices firmware. A configurable option is provided to enable or disable access via this protocol.
Table 9-17 FTP Settings
FTP Settings State
Port Data Port
Passive Mode Start Port Passive Mode Ports
Submit (button)
Description
Select to enable or disable the FTP...
User Guide - Page 57
... sending data aggressively within TCP Windows size limit, when file (including firmware upgrade) is uploaded from web page.
Select to enable or disable HTTP server logging: Enabled (default) Disabled
Set the maximum number of HTTP server log entries. Only the last Max Log Entries are cached and viewable.
EDS3000 Device Server User Guide
57
User Guide - Page 71
...that the certificate is an authority certificate type, the field
updates to PKCS12 automatically. For PKCS12 certificates, type a Password.
Notes: Ensure that the certificate is formatted properly...is set to None, the certificate is not supported. 6. Click Submit.
CSR (Certificate Signing Request)
The EDS3000 devices uses the Secure Socket Layer (SSL) protocol for any encrypted network ...
User Guide - Page 74
... Device. Uploading new firmware writes the new firmware file to firmware.rom on the EDS3000 devices. The gateway automatically reboots upon the installation of new firmware. See the section FTP on page 55.
Caution: Do not to power off or reset the EDS3000PR devices while uploading new firmware. Once the upload has completed and the new firmware has been verified and flashed to memory...
User Guide - Page 88
... to 8 custom roles can be created.
New Role Settings Name Actions
Configuration Groups
Description
Enter the name of a new role to be created.
Check the Actions that the new role will have access to, if any:
Device Reboot Factory Reset Firmware Upgrade
Check the Configuration Groups the new role will have...
User Guide - Page 89
... SSL groups must be imported with secrets manually filled in (e.g., passwords and private key) before import.
The exported file can be modified and imported to update the configuration on this EDS3000 devices or another.
XML records can also be exported to browser window or to a download link on the EDS3000 devices.
Notice that by default, all Groups to...