Netgear MBM621 - 3G HSDPA Ethernet Modem driver and firmware
Drivers and firmware downloads for this Netgear item
Related Netgear MBM621 Manual Pages
Download the free PDF manual for Netgear MBM621 and other Netgear manuals at ManualOwl.com
MBM621 Installation Guide - Page 1
... with wireless broadband coverage. Check with your Internet Service Provider (ISP) if you are not sure. • You need an activated SIM card from your ISP. • You must have a computer with an available Ethernet port to connect to the Mobile Broadband Modem. • Your computer must be configured with DHCP. • For installation with a router, first install the Mobile Broadband Modem to...
MBM621 Installation Guide - Page 2
...
Enabled or disabled GMT Disabled
SNMP
Disabled
To reset the modem, press and hold down the reset button for 5 seconds.
Technical Support
Contact your Internet Service Provider for technical support. Register your product at http://www.NETGEAR.com/register, so that you can check for firmware updates for the modem.
This symbol was placed in accordance with the European...
MBM621 Product datasheet - Page 1
...Auto Uplink 10/100 LAN Ethernet port that can connect directly to a computer, wireless router or switch, without the need for crossover cables.
HSDPA AirLink supports up to a 7.2 Mbps connection rate with receive diversity and equalizer, enabling service providers to deliver a true broadband experience wirelessly.
Diagram 1 MBM621 with direct connection to a computer
3G Mobile Network
PC
Diagram...
MBM621 Product datasheet - Page 2
....2, IEEE 802.3, ICMP, HTTP, TFTP, NTP
• Physical Interfaces - LAN port: One 10/100 Mbps auto-sensing Auto-MDI-X, RJ-45 port (one Cat 5 UTP cable included) - WAN: Embedded HSDPA module for Wireless WAN - SIM: Slot for SIM module
• LEDs - Power - Test - LAN - Internet
• Hardware Specifications - Memory: 4 MB flash, 16 MB DRAM - 2 dBi external whip...
MBM621 Reference Manual - Page 2
...NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Certificate of the Manufacturer/Importer
It is hereby certified that the Mobile Broadband Modem MBM621 has been suppressed in accordance with the conditions set... zu überprüfen.
Voluntary Control Council for Interference (VCCI) Statement
This equipment...
MBM621 Reference Manual - Page 5
... to a Computer 1-4 Power On the Modem and Computer 1-5 Log In to the Modem and Connect to the Internet 1-7 Broadband Settings ...1-8
Chapter 2 Settings and Maintenance Basic Settings ...2-1 Maintenance ...2-2 Modem Status ...2-3 Attached Devices ...2-4 Backup Settings ...2-5 Using the Reset Button 2-6 Setting the Password 2-7 Upgrading the Modem Firmware 2-7
Chapter 3 Advanced Settings Port...
MBM621 Reference Manual - Page 7
About This Manual
The NETGEAR® Mobile Broadband Modem MBM621 User Manual describes how to install, configure and troubleshoot the Mobile Broadband Modem MBM621. The information in this manual is intended for readers with intermediate computer and Internet skills.
Conventions, Formats and Scope
The conventions, formats, and scope of this manual are described in the following paragraphs: &#...
MBM621 Reference Manual - Page 8
Mobile Broadband Modem MBM621 User Manual
For more information about network, Internet, firewall, and VPN technologies, see the links to the NETGEAR website in Appendix B, "Related Documents"..
Note: Product updates are available on the NETGEAR, Inc. website at http://kbserver.netgear.com.
How to Use This Manual
The HTML version of this manual includes the following:
• Buttons,
and
, ...
MBM621 Reference Manual - Page 9
Mobile Broadband Modem MBM621 User Manual
- Click the print icon in the upper left of the window. Tip: If your printer supports printing two pages on a single sheet of paper, you can save paper and printer ink by selecting this feature.
• Printing the Full Manual. Use the Complete PDF Manual link at the top left of any page. - Click the...
MBM621 Reference Manual - Page 11
... Installation
The Mobile Broadband Modem MBM621 connects your computer or router to a broadband Interent service.
Package Contents
The product package should contain the following items: • Mobile Broadband Modem MBM621 • SIM card slot cover • AC power adapter (varies by region) • Category 5 (Cat 5) Ethernet cable • Two plastic feet that can be used to stand the Mobile...
MBM621 Reference Manual - Page 12
Mobile Broadband Modem MBM621 User Manual
Front View
The front view of the modem is shown below:
Figure 1-1
Understanding the LEDs
The following table explains how to interpret the lights on the front of the modem.
LED Power Status Internet
Ethernet
1-2
Activity
• Green: The modem is on and operating normally. • Off: Power is not supplied to the modem.
• Amber: Power-on...
MBM621 Reference Manual - Page 13
Rear View
Mobile Broadband Modem MBM621 User Manual
The rear panel of the modem has connectors, a slot for the SIM card, and a reset button.
Ethernet Power adapter connector
SIM card cover Reset
Figure 1-2
Modem Label
The label on the bottom of the modem includes important information such as the MAC address.
Figure 1-3
Installation
1-3
v1.0, November 2007
MBM621 Reference Manual - Page 14
Mobile Broadband Modem MBM621 User Manual
Installation
Note: If you will be using a router, first install the modem to work with a computer. Then install the router.
Follow these instructions to install the modem.
Install the SIM Card and Connect the Modem to a Computer
To connect the Modem: 1. Turn off your computer. 2. Insert your activated SIM card into the slot on the rear of the modem. 3. ...
MBM621 Reference Manual - Page 15
Mobile Broadband Modem MBM621 User Manual
4. Connect the Ethernet cable that came with your modem to an Ethernet local area network (LAN) port on your computer. and to the Ethernet port on the modem.
Figure 1-5
Power On the Modem and Computer
Follow these steps: 1. Plug in the power adapter to your modem.
Figure 1-6
Installation
1-5
v1.0, November 2007
MBM621 Reference Manual - Page 16
Mobile Broadband Modem MBM621 User Manual
2. Verify the following:
•
The Power light is lit after applying power to the modem.
•
The Status light comes on briefly and then goes off.
•
The Internet light comes on.
For more information about LEDs, see "Understanding the LEDs" on page 1-2.
3. Attach the feet to the modem, and adjust the antenna so...
MBM621 Reference Manual - Page 17
... needed. The Ethernet light on the modem lights up.
2. On your computer, open an Internet browser. 3. Connect to the modem by typing http://modemlogin.net or the IP address on the label at the
bottom of the modem in the address field of your browser. A login window opens:
Figure 1-8
4. Enter admin for the user name and password for the password, both...
MBM621 Reference Manual - Page 21
... 2-2. Modem Status Screen Settings and Statistics Firmware Version
HSDPA
Modem Identity Modem SW Version Modem Driver Version IMSI
IMEI
Operator Network Mode
Description
The firmware version of the modem. If you upgrade the firmware this will change. The type of wireless module used. The software version of the modem. The driver version for the wireless module. International Mobile Subscriber...
MBM621 Reference Manual - Page 25
... previously, you should do a new backup so that the saved settings file includes the new password.
Upgrading the Modem Firmware
The software of the Mobile Broadband Modem is stored in FLASH memory, and can be upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR website. If the upgrade file is compressed (.zip file), you must first extract the binary...
MBM621 Reference Manual - Page 26
... Broadband Modem MBM621 User Manual
To upgrade the modem firmware: NETGEAR recommends that you back up your configuration before doing a firmware upgrade. After the upgrade is complete, you might need to restore your configuration settings. 1. Download and unzip the new software file from NETGEAR.
The Web browser that you use to upload new firmware into the modem must support HTTP uploads. NETGEAR...
MBM621 Reference Manual - Page 35
Mobile Broadband Modem MBM621 User Manual
• Gateway IP Address. This must be a router on the same LAN segment as your modem. • Metric Value. Type a number between 2 and 15. This represents the number of routers
between your network and the destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 2. 4. Click Apply and the static route is...