LevelOne HVE-9001 driver and firmware
Related LevelOne HVE-9001 Manual Pages
Download the free PDF manual for LevelOne HVE-9001 and other LevelOne manuals at ManualOwl.com
Manual - Page 4
... (founder of HDMI) chipset embedded
— HDMI signal transmission via Cat.5/5e/6 cables — Cat.5/5e/6 cable implementation to minimize use of high-cost HDMI cable — Minimum 40m extension for 1080p resolution* — Maximum extension up to 80m** — Uncompressed, unmodified HDMI with 7.1-channel audio/video pure digital
transmission — Cascading virtually unlimited for HVE-9003...
Manual - Page 8
... different kinds of HDMI sources and displays. If you cannot get the audio and/or video output normally at the system installation, please change the DIP switch setting to default mode or even safe mode to verify the functionality of the device. 5 Set Pin#1 at ON[ª] first then connect the HDMI Input to HDTV through a HDMI cable. Wait for...
Manual - Page 10
... HDSpider™ 4-Port Cat.5 HDMI Sender
DIP Switch: Please see more detail in the table below HDMI INPUT: Connect to a HDMI source HDMI Signal OUTPUT 1 - 4: Link to each HDMI display via a Cat.5e/6 cable with HVE-9000,
HVE-9003, or HVE-9900. USB: For firmware update (technical support use only) +5V DC: interlocking power jack for 5V DC power supply unit
DIP Switch
DIP Switch Position
Pin...
Manual - Page 11
... at the system installation, please change the DIP switch setting to default mode or even safe mode to verify the functionality of the device. 5 For EDID learning function please see the next section.
EDID Learning
1. To make the HVE-9004 learn the EDID of the desired display, connect the display to the HDMI INPUT port via a HDMI cable.
2. Set the DIP...
Manual - Page 15
INSTALLATION
Extends HDMI signals to one display at longer distance
HVE-9000 & HVE-9001
1. Connect HVE-9001 to a HDMI source device with a HDMI cable. 2. Connect HVE-9000 to a HDMI display or projector with a HDMI cable. 3. Connect a Cat.5e/6 cable between HVE-9000 and HVE-9001. 4. Make sure this Cat.5e/6 cable is tightly connected and not loose. 5. Plug in a 5V DC power supply unit to the power ...
Manual - Page 22
... use HDSpider™ Long Range Cat.5 HDMI Receiver (HVE-9000) instead.
There is no image on display, what could be the problem?
First please check all cable is properly installed. Secondly check display source is functioning correctly.
It is still not working.
If problem persist, please try the EDID learning function on HVE-9001, HVE-9002, or HVE-9004.
21