Lantronix SISPM1040-3166-L driver and firmware
Drivers and firmware downloads for this Lantronix item
Related Lantronix SISPM1040-3166-L Manual Pages
Download the free PDF manual for Lantronix SISPM1040-3166-L and other Lantronix manuals at ManualOwl.com
Power-over-Ethernet Brochure - Page 2
...cameras, wireless access points, or IP phones - is yet another challenge. Power is often not available precisely where it is needed and adding conventional power wiring can be inconvenient and costly. Combining power and data on one cable with Transition Networks' full line of feature rich Power-over-Ethernet (PoE) products eliminates the need for conventional power wiring, eases your installation...
Power-over-Ethernet Brochure - Page 3
... VoIP phones at the desktops.
With PoE technology, the remote IP products are powered through the copper cable (typically Cat5 or better) that also transmits data. At the network core, a PoE, PoE+ or PoE++ switch can be installed to provide power and data to the IP devices on each port. Transition Networks offers a full range of network switches from 4 to 48 ports with Power...
SISPM1040-3166-L Datasheet - Page 1
... per port rate control
● Spanning Tree: Supports IEEE 802.1s MSTP, IEEE 802.1w RSTP and IEEE 802.1D STP Compliant
● VLAN: Port Based VLAN, IEEE 802.1Q tag-based, up to 4k VLAN entries, Q-in-Q, MAC-based VLAN, Management VLAN, Voice VLAN, Private VLAN
● Firmware Update through TFTP and HTTP/HTTPs
● E-Line, E-LAN...
Installation Guide Rev G - Page 2
.../21 4/12/22
Rev. Comments
E Correct humidity specs.
F
FW v8.50.0012: Include one step FW version update. Modify "Always On PoE" behavior to be enabled and displayed on Web UI after upgrade to FW v8.50.0018 or above. Fix API issues.
G Initial Lantronix rebrand. Update port descriptions.
33762 Rev. G
https://www.lantronix.com/
Page 2 of 48
Installation Guide Rev G - Page 4
Lantronix
SISPM1040-3xxx-L Install Guide
Contents
Safety Warnings and Cautions ...3
Chapter 1 - Introduction ...5
About This Manual...5 Related Manuals...5 Key Features ...6 Benefits...6 Ordering Information...7 Specifications ...7 Software Features ...17 Applications ...21 Front Panels ...22
LED Descriptions ...23 Reset Button ...24 Back Panels...25
Chapter 2 - Installing the Switch...26
...
Installation Guide Rev G - Page 5
...each device. For Lantronix Drivers, Firmware, etc. go to the Product Support webpage (logon required). For Lantronix Manuals, Brochures, Data Sheets, etc. go to the Support Library (no logon required). For SFP manuals see Lantronix SFP webpage.
Other related manuals are listed below. • SISPM1040-3xxx-L Quick Start Guide, 33761 • SISPM1040-3xxx -L Web User Guide, 33763 • SISPM1040...
Installation Guide Rev G - Page 17
Lantronix
SISPM1040-3xxx-L Install Guide
Software Features
Layer...1s Link Aggregation Control Protocol (LACP) IEEE 802.3ad Supports up to 4K VLANs simultaneously (out of 4096 VLAN IDs) Port-based VLAN 802.1Q tag-based VLAN MAC-based VLAN &#... actively filters IGMP packets in order to reduce load on the multicast router
Delivers IPv6 multicast packets only to the required...
Installation Guide Rev G - Page 19
Lantronix
IEEE 802.1ab (LLDP) Web GUI Interface CLI Dual Image SNMP Firmware Upgrade NTP
Other Management
Synchronization IEEE 1588v2 PTP Loop Protection ITU-T G.8031 ITU-T G.8032 Loop Detection Rapid Ring (R-Ring) MRP and MRP Rings Carrier Ethernet E-LINE
E-LAN
E-TREE E-ACCESS
SISPM1040-3xxx-L Install Guide
Used by network devices for advertising their identities, capabilities, and ...
Web User Guide Rev G PDF 14.13 MB - Page 2
... cause loss of data or damage the system or equipment.
SISPM1040-3xxx-L Web User Guide, 33763 Rev. G
Record of Revisions
Rev Date
Description of Changes
FW v8.50.0018: Include one step FW version update. Fix API "get fw upgrade status". Fix API response
if changing IP address. Fix Backup Config issue. Fix LLDP PMD Auto-Negotiation...
Web User Guide Rev G PDF 14.13 MB - Page 10
... device. For Transition Networks Drivers, Firmware, etc. go to the Product Support webpage (logon required). For Transition Networks Manuals, Brochures, Data Sheets, etc. go to the Support Library (no logon required). For SFP manuals see Transition Networks SFP webpage. Other related manuals are listed below.
• SISPM1040-3xxx-L Quick Start Guide, 33761 • SISPM1040-3xxx-L Install Guide...
Web User Guide Rev G PDF 14.13 MB - Page 193
Transition Networks
SISPM1040-3xxx-L Web User Guide
Chapter 12 - MAC Address Tables
12-1 Configuration
Switching of frames is based upon the DMAC address contained in the frame. The switch builds up a table that maps MAC addresses to switch ports for knowing which ports the frames should go to (based upon the DMAC address in the frame). This table contains both static and...
Web User Guide Rev G PDF 14.13 MB - Page 261
... special supplicant software to authenticate. The disadvantage is that MAC addresses can be spoofed by malicious users - equipment whose MAC address is a valid RADIUS user can be used by anyone. Also, only the MD5-Challenge method is supported. The maximum number of clients that can be attached to a port can be limited using the Port Security Limit Control functionality...
Web User Guide Rev G PDF 14.13 MB - Page 425
Transition Networks
SISPM1040-3xxx-L Web User Guide
Peer MAC : This field determines the destination MAC address used in generation of the test and delay measurement frames. This must be a non-zero unicast MAC address. Using a correct peer MAC address is critical if the Y.1564 uses Y.1731 LBM/DMM for test traffic and delay measurements (that is, 'DST is OAM-Aware' is...
Web User Guide Rev G PDF 14.13 MB - Page 453
... Networks
SISPM1040-3xxx-L Web User Guide
26-4 Firmware
This section describes how to upgrade (update) Firmware and lets you revert to the alternate firmware image.
24-4.1 Firmware Upgrade
This page lets you update the switch firmware. You can use the Non-Stop PoE function so that when the switch warm restarts, it will retain PoE supply to the PDs.
To update firmware of the device...
Web User Guide Rev G PDF 14.13 MB - Page 454
... Firmware Selection to display the Software Image Selection page. 2. Click the Activate Alternate Image button. 3. At the Are you sure ... confirmation prompt click OK or Cancel.
Figure 26-4.2 Software Image Selection Parameters: Image : The file name of the firmware image, from when the image was last updated (e.g., linux or linux.bk). Version : The version of the firmware image (e.g., SISPM1040...
Web User Guide Rev G PDF 14.13 MB - Page 484
... in the Dashboard.
6. Enter the TFTP server IP address and FW file name, and select the switch on which you want to upgrade the FW.
7. Click "Apply" to start the FW upgrade and save to Running-config.. 8. Observe the upgrade status until completion.
Messages
Starting, please wait... Error : Firmware download fail
33763 Rev. G
https://www.transition.com...
CLI Reference Guide Rev G PDF 2.18 MB - Page 2
.... G
Record of Revisions
Rev Date
Description of Changes
FW v8.50.0018:include one step FW version update. Fix API "get fw upgrade status". Fix response from API if changing IP address. Fix Backup Config issue. Fix LLDP PMD Auto-Negotiation Advertised Capability F 3/15/21 field. Fix MRP_Ring state "unknown" issue when cable removed. Add "PoE Firmware Version...
CLI Reference Guide Rev G PDF 2.18 MB - Page 5
...and Telnet Protocol.
1-3 Related Manuals
A printed Quick Start Guide is shipped with each device. For Transition Networks Drivers, Firmware, etc. go to the Product Support webpage (logon required). For Transition Networks Manuals, Brochures, Data Sheets, etc. go to the Support Library (no logon required). For SFP manuals see Transition Networks SFP webpage. Note that this manual provides links to...
CLI Reference Guide Rev G PDF 2.18 MB - Page 169
..., now rebooting.
SISPM1040-3248-L# Username SISPM1040-3248-L# firmware upgrade tftp://192.168.1.77/running-config Downloading... W firmware 00:25:23 256/execute#221: Warning: Timeout waiting for data exceeded Download failed: Timeout SISPM1040-3248-L# SISPM1040-3248-L# copy startup-config sftp://buck:[email protected]/startup-configradius save-host-key % startup-config: Load failed: Cannot...
API User Guide Rev C PDF 523.66 KB - Page 55
...-3166-L
SISPM1040-3166-L
Managed Hardened Gigabit Ethernet PoE+ Switch, (16) 10/100/1000Base‐T PoE+ ports + (4) 100/1000Base‐X SFP/RJ‐45 Combo + (2) 1G/10G SFP+
SISPM1040-3166-L
Record of Revisions
Rev. Date
Description
v8.50.0018: Fix API "get fw upgrade status". Fix response from API if changing IP address. Fix Backup B 3/15/21 Config issue. Add "PoE Firmware Version...